Plastic mold manufacturers solve electroplating problems from the front end and inspect the quality of mold blanks
During the electroplating process in injection mold manufacturers, quality inspection of the blank is one of the key steps in solving electroplating problems. If we only consider whether to use electroplated grade plastics and ignore the quality inspection of the plastic preform itself, it will be difficult to produce composite materials
Ge’s electroplated products. Compared to metal products, the inspection of plastic products is more difficult and requires experienced quality inspectors to accurately identify problems. Otherwise, quality issues such as “pitting” may occur after electroplating, which can affect product quality.
We can take the following measures to address this issue:
1. Plastic blanks need to have a quality inspection process set up, and experienced and familiar quality inspectors are responsible for plastic electroplating. Emphasizing this aspect can effectively improve the quality stability of electroplated products.
2. In the pre-treatment process, collision of the plated parts should be avoided. In the erosion process at around 70 ℃, ABS plastic will soften and increase, and its hardness will decrease. If collision occurs, it is easy to scratch the blank, resulting in printed spots after plating. Therefore, before processing
In each process, special attention should be paid to avoiding collisions.
3. Controlling the degree of erosion is also very important. The control of erosion degree can ensure that the surface condition of the plated part meets the appropriate requirements. Excessive or insufficient erosion can affect the glossiness and coating adhesion of the product. Currently, many people mistakenly believe that
The glossiness is achieved by relying on bright copper and nickel, neglecting the control of erosion degree, which is a problem that needs to be taken seriously.
By strengthening the quality inspection of plastic blanks, avoiding collisions, and controlling the degree of erosion, we can effectively solve the quality problems that occur during the electroplating process and improve the stability of product quality by solving electroplating problems from the front end
And glossiness. In the production process of injection mold manufacturers, emphasizing the quality inspection of raw materials is a key step to ensure product quality and an important measure to enhance the competitiveness of enterprises. I hope that all injection mold manufacturers can pay attention to this issue
Optimize production processes, improve product quality, and contribute to the development of the industry.