The plastic mold uses the inspection tool the notice
The plastic mold uses the inspection tool the notice, the injection molding processing factory has formulated the corresponding maintenance regulation regarding all the inspection tools, and makes the report form for the inspection technician to fill in uses. The benefit of doing this is to give the customer detailed product information, the key is that the information is traceable basis, so that if there is a lot of product production process in the future, we can analyze the nature of its products to change the specific date, to make the corresponding adjustment measures!
![Injection Mold Processing,mold,mould,Mold Processing,Mold design and manufacturing,Mold processing mold](/wp-content/uploads/replace/eb914829bf6ba470a16d31f9ba684812.jpeg)
Injection molding factory will check these general points for attention, to share with you, come to see you know a few bar: 1. Non-metrological testing devices shall not be used for testing, and those that have been knocked down or disassembled shall only be used if they have passed further testing. 2. There are some errors in the manual testing of product size. Different people, different checking tools and different testing points will cause errors. 3. The error of the vernier caliper is about ± 0.20mm, which is related to the difference of the human in the use of different force and reading. 4. When measuring the inside dimensions of a part, the actual dimensions are measured by adding the width of the corresponding two measuring feet. 5. If necessary, in the use of more sophisticated gauges, the need to wear gloves to work. Prevent perspiration from corroding the fixture. 6. After using the measuring tool, it is necessary to wipe its surface clean, and record the time of use, measuring product name number, measuring results, and then put the gauge back to its original position.