Injection mold processing test and repair
Although the test and repair of injection mold processing is to carry out mold planning, mold design and mold processing under the assumed skill conditions when selecting the molding materials and molding equipment of injection mold products, we all know that the assumed skill conditions are usually imperfect, so it is necessary to carry out the test of injection mold at the end of the processing of injection mold to see the quality of the parts of injection mold products. The defective points of the injection molding parts are found, and the injection mold is cleaned and repaired.
There are many varieties of injection molded parts with poor performance, and the reasons are also very messy. There are reasons for mold and skills. The two are usually only together. Before the repair of the injection mold, the designer of the injection mold should conduct a detailed analysis and research according to the actual situation of the adverse phenomenon of the plastic parts, find out the reasons for the defects of the plastic parts, and then put forward the remedies.
If the change of forming conditions is simple, the usual practice is to change the forming conditions first. When changing the forming conditions can not solve the problem, we can think about repairing the mold. The simple repair mold should be more stable. There is no very definite and feasible scheme, so it is not allowed to act rashly. The reason is that once the mold conditions are changed, it can not be greatly transformed and restored.
